HAL 107 (your choice)
Ordering Code: HAL 107TQ-C
Interface : 3-Wire
Unipolar, Low Sensitivity
BON 26.5 - BOFF 22.5
Note: The HAL 1xy sensor family is not recommended for new designs and is replaced by HAL 15xy
Block diagram – system architecture
The Hall-effect sensor is a monolithic integrated circuit that switches in response to magnetic fields. If a magnetic field with flux lines perpendicular to the sensitive area is applied to the sensor, the biased Hall plate forces a Hall voltage proportional to this field. The Hall voltage is compared with the actual threshold level in the comparator.
The temperature-dependent bias is used to compensate the decreasing induction of magnets at higher temperatures. If the magnetic field exceeds the threshold levels, the open-drain output switches to the appropriate state. The built-in hysteresis eliminates oscillation and provides switching behavior of output without bouncing.
Magnetic offset caused by mechanical stress is compensated for by using the “switching offset compensation technique”.