HAL 206 (your choice)
Ordering Code: HAL 206JQ-K
Interface : 3-Wire
Unipolar, High Sensitivity
Switching Points [mT] at 25°C:
BON 12.0 - BOFF 6.5
Note: The HAL 2xy sensor family is not recommended for new designs and is replaced by HAL 15xy
The HAL 2xy Hall switch family is produced in CMOS technology. The sensors include a temperature-compensated Hall plate with active offset compensation, a comparator, and an open-drain output transistor.
The comparator compares the actual magnetic flux through the Hall plate (Hall voltage) with the fixed reference values (switching points). Accordingly, the output transistor is switched on or off.
The active offset compensation leads to magnetic parameters which are robust against mechanical stress effects. In addition, the magnetic characteristics are constant in the full supply voltage and temperature range.
The sensors are designed for industrial and automotive applications and operate with supply voltages from 3.8 V to 24 V in the ambient temperature range from −40 °C up to 125 °C.
The HAL 2xy family is available in the SOT89B SMD package and in the leaded TO92UA package.
Block diagram – system architecture
The Hall-effect sensor is a monolithic integrated circuit that switches in response to magnetic fields. If a magnetic field with flux lines perpendicular to the sensitive area is applied to the sensor, the biased Hall plate forces a Hall voltage proportional to this field. The Hall voltage is compared with the actual threshold level in the comparator.
The temperature-dependent bias is used to compensate the decreasing induction of magnets at higher temperatures. If the magnetic field exceeds the threshold levels, the open-drain output switches to the appropriate state. The built-in hysteresis eliminates oscillation and provides switching behavior of output without bouncing.
Magnetic offset caused by mechanical stress is compensated for by using the “switching offset compensation technique”.